~~~~~

Conetrol has many computer printouts going into considerable detail on the various aspects of its product relative to pertinent firearms.  They are not on the www.conetrol.com web site; but phone, fax or e-mail will get any one of them on the way to you posthaste by U.S. Mail. And they just might leave you relishing a bit of particularly engrossing knowledge about that revered firearm you've long owned or wanted to.

Some samples of Conetrol printouts available...

• Information we will need to fit an unlisted firearm.
• Detachability of the Conetrol mounting system.
• Handguns, mounting offered.
• 7/8" ring liners (to reduce the size of 1" rings).
• Rimfire bases, Tip-Off grooved and drilled.
• Side mounts offered by Conetrol for split-bridge or top-ejecting gun actions.
• Solid rings for scopes with straight tube ends.
• Adjustments available in Conetrol mounting system.
• Kimber guns, mounting for.
• Mannlicher-Schonauer, side mounts for older-split bridge model.
• Mauser 66 and 660, mounts for.
• Remington XP100, 600, Model 7, mounts for.
• Ruger No 1's, mounts for.
• Ruger Mini-14 & 30, mounts for.
• Ruger DapTar bases, to fit Ruger mounting mechanism.
• Round-receiver Sakos, bases for.
• Model 52 Winchesters, which bases for old and new versions.
• Model 70 Winchesters, mounts needed for variations over the years.
• Exchanges (and Returns), Conetrol's policy on such.
• Ring caps, cost for replacing if lost.
• Metric-drilled guns, mounts for.
• DapTar bases and dovetails, variations in dimensions.

For ways to contact us for our computer printouts, see our 'Contact Us' page.

(Note: Our slate of computer printouts is subject to perpetual change. Your input is always welcome. If you have a suggestion for a printout that would be helpful to you, bring it on.
If it's something others might also benefit from, it could wind up as a material enhancement to the current crop of Conetrol printouts.)